projects:hardware:facuum

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
projects:facuum [2016/04/17 15:32] – [Fans] metalgamerprojects:hardware:facuum [2019/01/28 21:07] (current) – projects:facuum renamed to projects:hardware:facuum (Moved to correct category) metalgamer
Line 16: Line 16:
 | Red: +3V | Red/White: +3V | Orange: +3V | Orange/White: +3V | | Red: +3V | Red/White: +3V | Orange: +3V | Orange/White: +3V |
 | Black: Ground | Black/White: Ground | Grey: Ground | Grey/White: Ground | | Black: Ground | Black/White: Ground | Grey: Ground | Grey/White: Ground |
-| Yellow: N/A | Yellow/White: N/A | Brown: N/A | Brown/White: N/A |+| Yellow: Tachometric Signal | Yellow/White: Tachometric Signal | Brown: Tachometric Signal | Brown/White: Tachometric Signal |
  
 Sadly, these fans are not reversible, but there is a pin not connected on the PCB, maybe by soldering the +V wire to that pin, we can reverse the fan. Sadly, these fans are not reversible, but there is a pin not connected on the PCB, maybe by soldering the +V wire to that pin, we can reverse the fan.
  
 The voltage mentioned in the table, is the minimum voltage needed to start the fan. The maximum voltage is +23V after that, the fan start to lower their speed. The voltage mentioned in the table, is the minimum voltage needed to start the fan. The maximum voltage is +23V after that, the fan start to lower their speed.
  • projects/hardware/facuum.1460899979.txt.gz
  • Last modified: 2016/04/17 15:32
  • by metalgamer