chaosstuff:infrastructure:3d_printing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
chaosstuff:infrastructure:3d_printing [2019/08/26 10:29] – fantawamschaosstuff:infrastructure:3d_printing [2019/09/24 23:10] – peter
Line 3: Line 3:
  
 ^ Mentors | [[user:fantawams]] & [[user:metalgamer]] | ^ Mentors | [[user:fantawams]] & [[user:metalgamer]] |
 +
 +=== Material in the 3D-Printing Area ===
 +
 +  * Ultimaker 2
 +  * PLA
 +  * ABS
 +  * PETG
  
 Let's talk about 3D-Printers. Let's talk about 3D-Printers.
Line 32: Line 39:
 Example: \\ Example: \\
 PLA is very easy to print, when it has cooled down. it will become very though. on the other side it is not very resistant to water.\\ PLA is very easy to print, when it has cooled down. it will become very though. on the other side it is not very resistant to water.\\
-ABS on the other hand is resistant to water, but difficult to print. Also it is not very heat resistant.+ABS on the other hand is resistant to water, but difficult to print. Also it is not very heat resistant. \\ 
 + 
 +Most suppliers, like [[https://colorfabb.com/|colorfabb]] have detailed information, which print settings you should use for printing and of course the attributes of the material.
  • chaosstuff/infrastructure/3d_printing.txt
  • Last modified: 2022/03/03 22:48
  • by metalgamer