projects:freifunk:bugs

This is an old revision of the document!


Here you can find all the known bugs on the FreiFunk project and how to solve them.

stable

Firmware versionBugSolution
2.0.3 knows only old GW1 update to new Version
2.0.5 knows only old GW1 update to new Version
2.1.0 does not know new GW3 update to new Version
2.1.0 auto-update bug, nodes stuck in boot loop on firmware update POWER OFF/POWER ON node. Update to new Version. If update is not possible, re-flashing the node needs to be done.
2.1.1 does not know new GW3 update to new Version
2.1.1 auto-update bug, nodes stuck in boot loop on firmware update POWER OFF/POWER ON node. Update to new Version. If update is not possible, re-flashing the node needs to be done.

experimental

Keep in mind,that installing an experimental firmware on a router may brick the device. It should only be installed to test new firmware and new hardware.
Firmware versionBugwork-around
2.2.0~exp20181221 NO LAN IPV4 /
2.2.0~exp20181221 No config mode webgui after firmware update re-flashing the node
2.2.0~exp20190328 NO LAN IPV4 /
2.2.0~exp20190328 No config mode webgui after firmware update re-flashing the node
2.2.0~exp20190717 NO LAN IPV4, may come from network /
Bugreasonsolutionwork-around
IP distribution on nodes / / reboot the node
  • projects/freifunk/bugs.1568233082.txt.gz
  • Last modified: 2019/09/11 22:18
  • by fantawams