projects:freifunk:bugs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
private:freifunk:bugs [2020/02/03 18:22] – [network] fantawamsprojects:freifunk:bugs [2021/10/19 20:32] (current) – ↷ Page moved from private:projects:freifunk:bugs to projects:freifunk:bugs fantawams
Line 3: Line 3:
  
 ==== Firmware ==== ==== Firmware ====
-=== stable ===+<note important>Keep in mind,that installing an experimental firmware on a router may brick the device. It should only be installed to test new firmware and new hardware.</note> 
 ^ Firmware version  ^ Bug                                                           ^ Solution                                                                                                                    ^ ^ Firmware version  ^ Bug                                                           ^ Solution                                                                                                                    ^
 | 2.0.3             | knows only old GW1                                            | update to at least Version 2.3                                                                                              | | 2.0.3             | knows only old GW1                                            | update to at least Version 2.3                                                                                              |
Line 11: Line 12:
 | 2.1.1             | does not know new GW3                                         | update to new Version                                                                                                       | | 2.1.1             | does not know new GW3                                         | update to new Version                                                                                                       |
 | 2.1.1             | auto-update bug, nodes stuck in boot loop on firmware update  | POWER OFF/POWER ON node. Update to at least Version 2.3. If update is not possible, re-flashing the node needs to be done.  | | 2.1.1             | auto-update bug, nodes stuck in boot loop on firmware update  | POWER OFF/POWER ON node. Update to at least Version 2.3. If update is not possible, re-flashing the node needs to be done.  |
- 
-=== experimental === 
-<note important>Keep in mind,that installing an experimental firmware on a router may brick the device. It should only be installed to test new firmware and new hardware.</note> 
- 
-^Firmware version^Bug^work-around^ 
 | 2.2.0~exp20181221 | NO LAN IPV4, comes from network | / | | 2.2.0~exp20181221 | NO LAN IPV4, comes from network | / |
 | 2.2.0~exp20181221 | No config mode webgui after firmware update | re-flashing the node | | 2.2.0~exp20181221 | No config mode webgui after firmware update | re-flashing the node |
Line 22: Line 18:
 | 2.2.0~exp20190717 | NO LAN IPV4, comes from network | / | | 2.2.0~exp20190717 | NO LAN IPV4, comes from network | / |
 | 2.2.0~exp20190909 | NO LAN IPV4, comes from network. contact info is not mandatory | /| | 2.2.0~exp20190909 | NO LAN IPV4, comes from network. contact info is not mandatory | /|
 +| < 2020.X | does not know new GW2 | update the node to at least Gluon 2020.x |
 +| < 2020.2.3 | does not know new GW1 | update the noew at least Gluon 2020.2.3 |
  
 ==== network ==== ==== network ====
  • projects/freifunk/bugs.1580750557.txt.gz
  • Last modified: 2020/02/03 18:22
  • by fantawams