This is an old revision of the document!
We will perhaps buy the Ultimaker3, if money allows it .
Why the Ultimaker3?
* It has the same precision as his predecessor but with 2 nozzels from the start.
* The nozzles are far easier to change than on the Ultimaker 2 and the cooling was improved.
* You can heat the nozzle up to 280 degrees, which makes it possible to use even an bigger variety of materials.
* You can finally use the printing over the USB-port not just over SD-card.
Thanks to one of our members - who made us aware of the opportunity the commune of Esch-Uelzecht has been offering - we have participated on the “KUFA-Workshops 2013” (Flyer PDF) event in end of August of '13.